Table of Contents
Advertisement
Attaching the Paper Support
Insert the paper support into the slots at the rear of the printer and place
the printer on a flat, stable surface.
Connecting the Printer
Your printer connects to your computer via the parallel or USB interface.
Macintosh computers can only be connected via the USB interface.
Depending upon your geographic location, you may need to obtain the
appropriate cable. See "Options and Consumable Products" in the Daily
Use guide for details.
Note:
In order to connect your PC via the USB interface, your computer must be a
Windows Me, 98 or Windows 2000 pre-installed model that comes with a USB
port, or Windows Me upgraded from a Windows 98 pre-installed model.
Using a parallel interface for Windows users
To connect the printer to your PC, you need a shielded, twisted-pair
parallel cable. Follow the directions below.
1. Make sure that both the printer and the computer are turned off.
2. Plug the cable connector securely into
the printer's interface connector. Then
squeeze the wire clips together until
they lock in place on both sides. If your
printer has a ground connector screw to
the right of the interface connector,
connect the ground wire to the ground
connector screw.
3. Plug the other end of the cable into the computer's parallel interface.
If there is a ground wire at the computer end of the cable, connect it
to the ground connector at the back of the computer.
Advertisement
Table of Contents
