Tachometer Signal Type - Ford F100 1953 Installation Manual

Tachometer Signal Type:

1) Tap the pushbutton until the tachometer points to 2000 RPM
(tachometer signal type option). Fig. 5
2) Press and hold (4 seconds) the pushbutton to enter the
tachometer signal type mode. The speedometer will point to
the current setting (50 MPH for 5V signal or 120 MPH for
12V signal). Note: Use 5V setting if tachometer signal
comes from a computer. For any other signal use 12V.
3) Tap the pushbutton until the correct tachometer signal type
setting is selected.
4) Press and hold the pushbutton to save the setting. The
speedometer pointer will again indicate 70 MPH and the
tachometer will point to 8000 RPM (exit). Tachometer signal
type is now set.
5) If you are finished making setup
changes, press and hold the
pushbutton with the tachometer
pointing to 8000 RPM to exit setup
mode. Fig. 6
Revised September 13, 2013
FIG. 6