Ford F100 1953 Installation Manual page 11

Nut
Lock Washer
Washer
Oil Pressure Sender
[SN52]
Figure 1: Oil Pressure Sender Wiring
Nut
Lock Washer
Washer
Temperature Sender
Part Number:
SN25, SN24,
SN23, SN22 or
SN12mm
Figure 2: Temperature Sender Wiring
Ring Terminal
To position 6 of circuit board
connector plug.
Signal Wire
45° Elbow
Do not use teflon tape on the oil pressure
Entension
sender or extension threads because this
interferes with the sender's ground
connection.
Engine Block
Ring Terminal
Signal Wire
Intake Manifold
Do not use teflon tape on the threads of
the sender (except SN12mm) since this
interferes with the sender's ground
connection. SN12mm requires a
copper crush washer to supply a ground
to the sender.
Revised September 13, 2013
To position 7 of circuit board
connector plug.