Tachometer Setup; Cylinder Select - Ford F100 1953 Installation Manual

Tachometer Setup:

Cylinder Select:

1) Tap the pushbutton until the
tachometer points to 1000 RPM
(tachometer cylinder setup
option). Fig. 3
2) Press and hold (4 seconds) the
pushbutton to enter the tachometer
cylinder setup mode. The
speedometer will point to the current
cylinder number setting (40 MPH for 4
cylinders, 60 MPH for 6 cylinders, etc...).
3) Tap the pushbutton until the correct setting is selected.
4) Press and hold the pushbutton to save the setting. The
speedometer pointer will again indicate 70 MPH and the
tachometer will point to 8000 RPM (exit).
Tachometer cylinder selection is now
set.
5) If you are finished making setup
changes, press and hold the
pushbutton with the tachometer
pointing to 8000 RPM to exit
setup mode. Fig. 4
Revised September 13, 2013
6 CYL. 8 CYL.
4 CYL.
FIG. 3
FIG. 4