Table of Contents
Advertisement
Handset battery charging
Once you have installed the battery, the screen indicates the battery status (see the
table below).
•
For best performance, keep the handset in the handset charger when not in use.
•
The battery is fully charged after hours of continuous charging.
•
If you place the handset in the handset charger without plugging in the battery, the
screen displays NO BATTERY.
Battery indicators
The screen is blank, or
shows Put in charger and
flashes.
The screen shows
Low battery and
flashes.
The screen shows
HANDSET X.
When it is fully charged, you can expect the following performance:
Operation
While in use (talking*)
While in speakerphone mode (talking*)
While not in use (standby**)
* Operating times vary depending on your actual use and the age of the battery.
** Handset is not charging or in use.
Add and register a handset
You can add new handsets (DS6601, purchased separately) to your telephone
system. Each handset must be registered with the telephone base before use.
When first purchased and properly charged, each expansion handset displays
To register HS... and ...see manual alternately. You may need to charge the
handset before registering it to the telephone base.
To register a handset:
.
On the telephone base, press and hold FIND HANDSET
for about four seconds until the IN USE light turns on and it
shows Registering...
.
On the cordless handset, press QUIET
Registering... Both the telephone base and cordless
handset show Registered and you hear a beep when the
registration process completes. The registration process
takes about 60 seconds to complete.
If registration fails, the handset displays Failed. Try again the
registration process above.
Deregister handsets
If you want to replace a handset or reassign the designated handset number of a
registered handset, you must deregister all handsets and then individually register
each handset.
To deregister all handsets:
.
Press and hold FIND HANDSET on the telephone base for about 0 seconds
until the telephone base shows Registering... then De-register? The IN USE
light flashes.
.
Immediately press and release MENU/SELECT or FIND HANDSET. The
telephone base displays Please wait.
3.
All handsets show To register HS... and ...see manual alternately when the
deregistration process completes. The deregistration process takes about
0 seconds to complete.
Battery status
The battery has no charge or
very little charge. The handset
cannot be used.
The battery has enough
charge to be used for a
short time.
The battery is charged.
#
then it shows
3
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
To keep the battery charged,
place it in the handset
charger when not in use.
Operating time
Up to 7 hours
Up to 3.5 hours
Up to 5 days
Action
Advertisement
Table of Contents
