Battery Charging; Add And Register A Handset; Deregister Handsets - VTech CS6509 User Manual

Battery charging

Once you have installed the battery, the screen indicates the battery status
(see the table below).
• For best performance, keep the handset in the telephone base or charger when
not in use.
• The battery is fully charged after  hours of continuous charging.
• If you place the handset in the telephone base or the charger without plugging
in the battery, the screen displays NO BATTERY.
Battery indicators
The screen is blank, or
displays Put in charger
and flashes.
The screen displays
Low battery and flashes.
The screen displays
HANDSET X.
When the battery is fully charged, you can expect the following performance:
Operation
While in handset use (talking*)
While in speakerphone mode (talking*)
While not in use (standby**)
*Operating times vary depending on your actual use and the age of the battery.
**Handset is not charging or in use.

Add and register a handset

You can add new handsets (CS6509/CS6509-14/CS6509-15/CS6509-16/
CS6509-17/CS6509-19, purchased separately) to your telephone system. Each
handset must be registered with the telephone base before use. When first
purchased, each expansion handset displays To register HS and See manual
alternately. You may need to charge the handset before registering it to the
telephone base.
To register a handset:
. Place the new (non-registered) handset in the telephone base.
CS6519 base
. After about 0 seconds, the handset displays Registering... When the
registration process completes, the handset displays Registered and you
hear a beep. The registration process takes about 90 seconds to complete.

Deregister handsets

If you want to replace a handset or reassign the designated handset number of
a registered handset, you must deregister all the handsets and then individually
register each handset.
To deregister all handsets:
Press and hold FIND HANDSET on the telephone base for about 0 seconds
.
until the IN USE light on the telephone base turns on and starts to flash.
Immediately press FIND HANDSET again. You must press FIND HANDSET
.
while the IN USE light is still flashing. The IN USE light flashes for approximately
five seconds.
All handsets display To register HS and See manual alternately when the
3.
deregistration process completes. The deregistration process takes about
0 seconds to complete.
Battery status
The battery has no or very little
charge. The handset cannot
be used.
The battery has enough charge
to be used for a short time.
The battery is charged.
CS6529 base
3
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(about 30 minutes).
To keep the battery charged,
place it in the telephone
base or charger when not
in use.
Operating time
Up to 7 hours
Up to 3.5 hours
Up to 5 days
Do not place the handset
in the charger.