Mounting & Dismounting Instructions - Blizzard Power Plow 810SS Assembly & Operation Manual

Mounting & Dismounting Instructions
Prior to operating your Power Plow, review the Mounting & Dismounting
Instructions label at the driver's side rear of the moldboard (shown below).
MOUNTING
1. Position the skid steer close to the snowplow attachment and align the mount
points on the skid steer plate to those on the plow attachment plate.
2. Tilt the skid steer plate forward and position the top edge of the plate under
the receiving pocket on the top edge of the snowplow attachment plate.
CAUTION: Keep fingers away from skid steer mounting points. Slightly
raise the arms on the skid steer and tilt the skid steer plate toward the cab.
The snowplow attachment should now be flush with the skid steer mount.
3. Engage both locking levers on the skid steer by rotating each handle 90˚ into
a horizontal position. The attachment is now properly fastened to the skid steer.
4. Proceed to attach both 3/4" diameter hydraulic hoses from the manifold to
the auxiliary hydraulic connections located on the skid steer. Note: Depending
on the skid steer model, it may be necessary to initiate an auxiliary hydraulic
switch on the skid steer prior to operating the plow.
5. Complete the mounting procedure by attaching the electrical connection on
the wire harness to the auxiliary electrical connection on the skid steer.
Plow Attachment
SKID STEER MOUNTING &
DISMOUNTING INSTRUCTIONS
DISMOUNTING
1. Lower the attachment on a flat, level surface and turn the engine off.
2. Disconnect the electrical connection at the auxiliary power location.
3. Disconnect both 3/4" diameter hydraulic hoses from the auxiliary hydraulic
connectors.
4. Disconnect the snowplow attachment by rotating both of the locking levers
90˚ until they are in the vertical position.
5. Start engine and slowly tilt the skid steer plate forward until the top edge of
the plate clears the plow attachment plate.
6. Back skid steer away slowly – The disconnect procedure is now complete.
WARNING: Read and understand all warning labels prior
to operating your skid steer attachment. Failure to follow
this instruction may result in serious injury or death.
B
C
A
B
Lever
Receiving
Holes
A Skid steer plate attaches under the
top lip of the snowplow attachment.
B With the attachment flush to the
skid steer plate, engage both lock-
ing levers on the skid steer. Rotate
each handle 90˚ into a horizontal
position. The levers will slide through
the receiving holes in the snowplow
attachment plate. The plate is now
securely mounted to the skid steer.
C Connect both hydraulic hoses & the
electrical harness to the skid steer.
Should the Mounting & Dismounting Instructions
label or any of the labels that came with your
snowplow become hard to read or wear off, contact
your local dealer or call our authorized Blizzard
Dealer for replacements.
Mounting & Dismounting Instructions
BLZ 1014
09