Epson LQ-1050 User Manual page 260

Switching between
single sheets and
continuous paper
cannot be
performed properly
(continued).
Even with the paper
release set
lever
correctly to the single-
sheet position, the
single sheet and
continuous paper feed
together and jam.
The short tear-off
function does not
operate properly.
One page is completely
printed, but the paper
does not feed.
Printing ended in the
middle of a page-
7-26 Troubleshooting
Solution
The continuous paper may not have fed
backward far enough to reach the standby
position before you changed the position
of the paper release lever. Remove
jammed paper and try again. Also, check
that the
PAPER OUT
changing the position of the paper release
lever to make sure that the continuous
paper is completely ejected. When there is
more than one page to eject, you must
press the
LOAD/EJECT
Chapter 2.
once. See
DIP switch 2-7, short tear-off mode,
be set to off. Set DIP switch 2-7 to on to
turn on the short tear-off mode.
One page of data may not have been sent
to the printer. Finish the page by sending
a form feed code (FF) to the printer or by
sending enough line feed codes (LF) to
advance the remainder of the page.
light comes on before
button more than
the
may