Tools And Materials Needed For Installation - United States Stove Company HotBlast 1331E Owner's Operation And Instruction Manual

Hide thumbs

Table Of Contents

Table of Contents

• WARNING: Do not operate with fuel loading or ash removal doors open.

• Do not connect this unit to a chimney ﬂue serving another appliance.

• WARNING DANGER: Risk of fire or explosion. Do not burn garbage, gasoline, naphtha, motor oil, or other

inappropriate materials. Do not use chemicals or ﬂuids to start the fire.

• WARNING: Risk of fire. Do not operate with ﬂue draft exceeding .060" water column/14.93 Pascals. Do not

operate with fuel loading and ash removal doors open. Do not store fuel or other combustible materials

within marked installation clearances. Inspect and clean ﬂues and chimney regularly.

• CAUTION: Hot surfaces. Keep children away. Do not touch during operation.

• The heat exchanger, ﬂue pipe, and chimney must be cleaned regularly to remove accumulated creosote

and ash. Ensure that the heat exchanger, ﬂue pipe, and chimney are cleaned at the end of the heating

season to minimize corrosion during the summer months. The appliance, ﬂue pipe, and chimney must be

kept in good condition. These instructions also apply to a draft inducer if used. To prevent ﬂame or smoke

spillage, the slide bafﬂe must be pulled out and the fuel loading door left cracked for 10 seconds prior to

opening door fully. Load fuel carefully or damage may result.

• Hot while in operation. Keep children, clothing and furniture away. Contact may cause skin burns.

• Do not use chemicals or ﬂuids to ignite the fire.

• Do not leave the furnace unattended when the door is slightly opened.

• Do not burn garbage, ﬂammable ﬂuid such as gasoline, naphtha or motor oil.

• Always close the door after the ignition.

• Consult your municipal building department or fire officials about permits, restrictions and installations

requirements in your area.

• INSPECT FLUE PIPES, FLUE PIPE JOINTS, AND FLUE PIPE SEALS REGULARLY TO ENSURE THAT SMOKE AND FLUE

GASES ARE NOT DRAWN INTO, AND CIRCULATED BY, THE AIR-CIRCULATION SYSTEM.

• CAUTION: CLEAN OUT OF THE HEAT EXCHANGER, FLUE PIPE CHIMNEY, AND DRAFT INDUCER, IF USED, IS

ESPECIALLY IMPORTANT AT THE END OF THE HEATING SEASON TO MINIMIZE CORROSION DURING THE SUMMER

MONTHS, CAUSED BY ACCUMULATED ASH.

UNPACKING

1. Remove all packaging from the furnace.

2. Remove the supplied parts from the furnace.

BRICK ALIGNMENT

Inspect for any damage. Ensure that the bricks and

ash plug are positioned correctly and not broken (see

illustration for proper brick arrangement).