Epson Apex 80 User Manual page 17

6. In each tractor slot, located at each side of the paper slot, is a peg
that fits into the notch on each of the rear tractor legs. Tilt the
tractor back so that the rear notches fit over these pegs. See
Figure 1-9.
Figure 1-9.
Installing the tractor unit
7. Then tilt the unit forward until the front legs snap into place.
Loading continuous-feed paper
Once the tractor unit is installed, load continuous-feed paper as
follows:
1. Make sure that the printer is turned off.
2. Remove the front lid of the printer.
3. Move the print head to the center of the printer. Remember, the
printer must be turned off whenever you move the print head.
Also, if you've been using the printer, the print head may be hot. Be
careful not to touch it unless you let it cool for a few minutes.
1-10
Setting
Up