Problems And Solutions - Epson Stylus CX6000 Series Quick Manual

Screen display

Problems and Solutions

Check the solutions below if you're having trouble using your Epson Stylus
CX6000 Series all-in-one.
Printing and Copying Problems
■
Make sure your original is positioned in the top left corner of the glass. If the
edges are cropped, move your original away from the edges slightly.
■
Make sure your paper is loaded short edge first and is positioned against the
right edge guide with the left edge guide against its left side. Don't load paper
above the arrow mark inside the left edge guide.
44
Solving Problems
Cause
An unsupported device is
connected to the
port on the front.
The paper thickness lever
^
is set to the H position.
An CX6000 Series part
needs to be replaced.
There is a problem with the
CX6000 Series.
Solution
Disconnect the device.
(USB)
If you have set the lever to the
^
H position because you are printing
envelopes, press x Start to continue.
Otherwise, set the lever to the
m
L position.
Contact your local authorized servicer or
contact Epson for a referral; see page 46.
Turn the CX6000 Series off and then back
on. If the error does not clear, contact your
local authorized servicer or contact Epson
for a referral; see page 46.