Problems And Solutions; Copying Problems; Paper Feeding Problems - Epson Stylus CX7700 Basic Manual

Problems and Solutions

Check the solutions below if you're having trouble using your Epson Stylus
CX7700.

Copying Problems

■
Make sure your original is positioned in the top left corner of the glass. Place
it 5 mm (0.2 inch) from the edges to avoid cropping.
■
Make sure your paper is loaded short edge first and is positioned against the
right edge guide with the left edge guide against its left side. Don't load paper
above the arrow mark inside the left edge guide.

Paper Feeding Problems

■
If paper doesn't feed, remove it from the sheet feeder. Flip through the stack to
separate the sheets a little. Then reload the paper against the right edge guide,
and slide the left edge guide against the paper (but not too tightly). Make sure
the paper is not in front of the feeder guard.
■
Do not load too many sheets at once (up to 20 sheets of photo paper or 100
sheets of plain paper). See the User's Guide for more information.
■
If paper is jammed, follow these steps to clear the jam:
1. Press the x
is not ejected, go to the next step.
2. If the paper is stuck near the sheet feeder or output tray, gently pull it out.
If the paper is stuck inside the Epson Stylus CX7700, press the P
button to turn it off. Open the scanner and remove any paper inside,
including any torn pieces. Do not pull it backward however; this can
damage the sheet feeder. Close the scanner, then turn the Epson Stylus
CX7700 back on.
48
Solving Problems
button to eject the jammed paper. If the jammed paper
Start
On