Mower Deck Adjustment (Side To Side, 42" & 48" Decks) - Snapper YARD CRUISER HYDRO DRIVE 2 Series Safety Instructions & Operator's Manual

Section 4 - ADJUSTMENTS & REPAIR
WARNING
DO NOT attempt any adjustments, maintenance or
service with the engine or blade running. STOP
blade. STOP engine. Set brake. Remove key. Remove
spark plug wire from spark plug and secure wire
away from spark plug. Engine and components can
be extremely hot. Avoid burns by allowing engine
and components sufficient time to cool.
4.2.8. MOWER DECK ADJUSTMENT (LEVELNESS)
1. Side-To-Side (42" & 48" Decks)
Before making deck leveling adjustments, check
the tire pressure. Check tires and add or release air
as needed to bring pressure to 12 P.S.I. in front and 12
P.S.I. in rear tires. If tires are properly inflated and
mowing is still uneven, adjust side-to-side deck
levelness as follows:
a. Place YARD CRUISER on a smooth level
surface.
b. Turn engine off and remove key, remove
spark plug wire(s) from spark plug(s) and secure
wire(s) away from plug(s).
c. Place a piece of angle iron, pipe, or similar
object under center of deck at the rear.
d. Remove rear hanger chains and allow center,
rear of deck to rest on angle iron.
e. Measure the distance from blade tips to floor. If
the measurement is within 1/8" from side-to-side,
the deck levelness is satisfactory. If the difference
from side-to-side is greater than 1/8", continue to
the next page for adjustment. See Figure 4.7.
FRONT OR REAR VIEW OF DECK
TWIN BLADE DECK
X
SIDE
SINGLE BLADE DECK
FIGURE 4.7
X
SIDE
X - 1/8"
SIDE
ANGLE
IRON
X - 1/8"
SIDE
ANGLE IRON
f. Loosen the shoulder bolt that retains the
eccentric.
g. Turn eccentric "UP" or "DOWN" as required
until blade tips are within 1/8" of the same
distance from the floor. See Figure 4.8.
h. Tighten shoulder bolt loosened in Step "f".
i. Readjust rear hanger chain pivots to align
with holes in support brackets.
j. Reconnect hanger chains, remove angle iron,
pipe, etc. and recheck side to side level. Adjust
either chain as needed to result in blade tips
being within 1/8" of the same distance from the
floor.
k. Proceed to check front to rear deck pitch.
42" DECK SHOWN
DOWN
FRONT
LIFT ARM
(Continued On Next Page)
18
UP
LOOSEN
SHOULDER
BOLT
ECCENTRIC
FIGURE 4.8