Upper Glass Cover - Siemens HX9S7RI40N Instruction Manual

Appliance door
en
Installation
During installation, make sure that the lettering "right
above" is upside down at the bottom left of both panels.
Insert the lower panel at an angle towards the back
1.
(fig. A).
Slide in the middle panel (fig. B).
2.
Stick the retaining clips onto the right and left-hand
3.
side of the panel, aligning them so that the retaining
carriers are over the screw holes, and then screw
into place (fig. C).
Hook the seal in to the bottom of the panel again
4.
(fig. D).
Insert the uppermost panel at an angle to the back
5.
into the brackets. Take care not to push the seal to
the back (fig. E).
Insert the two small seals on the left and right of the
6.
panel again (fig. F).
Put the cover back in place and screw it on.
7.
Attach the oven door.
8.
Do not use the oven again until the panels have been
correctly installed.
32

Upper glass cover

Before opening the top cover, remove any spills with a
cloth.
Use glass cleaner if possible.
For cleaning, remove the top cover. To do this, hold the
cover securely on both sides with both hands and pull it
upwards.
If the cover hinges become loose, note the letters
marked on them. The hinge with the letter R must be
fitted on the right, and the hinge with the letter L must
be fitted on the left.
After cleaning, re-assemble the top cover following the
same procedure in reverse order.
Only close the top cover once the burners have cooled
down.