Removing And Installing The Door Panels - Siemens HX9S7RI40N Instruction Manual

Attaching the door
Reattach the oven door in the reverse sequence to
removal.
When attaching the oven door, ensure that both
1.
hinges are inserted straight into the opening
(figure A).
The notch on the hinge must engage on both sides
2.
(figure B).
Fold back both locking
3.
levers (figure C). Close the oven door.
:
Warning – Risk of injury!
If the oven door falls out accidentally or a hinge snaps
shut, do not reach into the hinge. Call the after­sales
service.

Removing and installing the door panels

To facilitate cleaning, you can remove the glass panels
from the oven door.
When removing the inner panels, pay attention to the
sequence in which the panels are removed. In order to
reassemble the panels in the correct sequence, use the
numbers that appear on each panel.
Removal
Detach the oven door and lay it on a cloth with the
1.
handle facing down.
Unscrew the cover at the top of the oven door. To do
2.
this, unscrew the left and right screws (fig. A).
Lift the top panel up and pull it out and remove the
3.
two small seals (fig. B).
Unscrew the retaining clips on the right and left. Lift
4.
the panel and remove the clips from the panel
(fig. C).
Remove the seal from the bottom of the panel (fig.
5.
D). Pull the seal and remove it up and out. Pull out
the panel.
Pull the lower panel at an angle, upwards and out.
6.
Do NOT unscrew the left and right-hand screws from
7.
the sheet metal part (fig. E).
Clean the panels with glass cleaner and a soft cloth.
:
Warning – Risk of injury!
Scratched glass in the appliance door may develop into
a crack. Do not use a glass scraper, sharp or abrasive
cleaning aids or detergents.
Appliance door
en
31