MULTIQUIP MIX N' GO MC3SE Operation And Parts Manual page 7

■ NEVER Run engine without air cleaner. Severe engine
damage may occur.
■ ALWAYS read, understand, and follow procedures in
Operator's Manual before attempting to operate equipment.
■ ALWAYS be sure the operator is familiar with proper safety
precautions and operations techniques before using roller.
■ ALWAYS store equipment properly when it is not being used.
Equipment should be stored in a clean, dry location out of the
reach of children.
■ NEVER leave the mixer unattended, turn off engine or electric
motor when unattended.
■ CAUTION must always be observed while servicing this mixer.
Rotating parts can cause injury if contacted.
■ Unauthorized equipment modifications will void all
warranties.
■ Ensure that any trailing cable is protected against damage
and not liable to be tripped over or trapped underneath the
mixer.
■ Ensure any extention cables must be no longer than 30 meters
(100 feet) in length and that the wire section is 2.5 mm
■ DO NOT allow extension cord to come into contact with water
or fluids.
■ DO NOT spray water onto electric motor.
■ DO NOT expose power tools to rain or wet conditions.
■ This mixer is intended for the production of concrete, mortar
and plaster. Mixer must be used only for its intended purpose.
■ This mixer is not suitable for the mixing of flammable or
explosive substances.
■ NEVER operate the mixer in an explosive atmosphere.
■ Before starting the mixer, check that all guards are in position
and correctly fitted.
■ DO NOT tip mixer onto drum mouth when the motor is running.
■ Keep area around the mixer clear of obstructions which
could cause persons to fall onto moving parts .
■ ALWAYS ensure mixer is on level ground before mixing.
■ Become familiar with the controls of the machine before
operating.
■ ALWAYS replace any worn or damaged warning decals.
■ Ensure the drum is rotating while filling and emptying the
drum.
■ ALWAYS disconnect AC power plug from power source
before moving mixer (electric model only).
MIX N' GO MIXER — OPERATION & PARTS MANUAL — REV. #5 (11/07/05) — PAGE 9
RULES FOR SAFE OPERATION
■ High Temperatures – Always stop engine and allow the
engine to cool before adding fuel, oil or performing service
and maintenance functions. Contact with hot components can
cause serious burns.
■ NEVER disconnect any "emergency or safety devices" .
These devices are intended for operator safety. Disconnection
of these devices can cause severe injury, bodily harm or even
death! Disconnection of any of these devices will void all
warranties.
■ If mixer is equipped with an electric motor, operate only at
120 VAC, 60 Hz.
■ Make sure the OFF/ON power switch is always in the OFF
position before inserting the mixer's power plug into an AC
receptacle (electric model only).
Maintenance Safety
■ NEVER lubricate components or attempt service on a running
machine.
■ ALWAYS allow the machine a proper amount of time to cool
before servicing.
■ Keep the machinery in proper running condition.
2 .
■ Fix damage to the machine immediately and always replace
broken parts, or missing decals.
■ Dispose of hazardous waste properly. Examples of potentially
hazardous waste are used motor oil, fuel and fuel filters.
■ DO NOT use food or plastic containers to dispose of
hazardous waste.
■ DO NOT pour waste, oil or fuel directly onto the ground,
down a drain or into any water source.