MULTIQUIP MIX N' GO MC3SE Operation And Parts Manual page 18

6. Tip mixer onto mouth as shown in Figure 10, and insert
support stand into frame swivel point.
Figure 10. Attaching Support Stand
7. Remove both wheels and wheel retainers from the packing
container.
8. Place one wheel on each side of the mixer's axle as shown
in Figure 11. Position wheel retainer over axle to secure
wheel in place. Use a rubber mallet when striking wheel
retainer.
Figure 11. Wheels and Wheel Retainers
PAGE 20 —MIX N' GO MIXER — OPERATION & PARTS MANUAL — REV. #5 (1/07/05)
MIX N' GO MIXER — ASSEMBLY INSTRUCTIONS
9. Before attempting to lift mixer, locate the frame locking clip.
Attach the locking clip as shown in Figure 12. This will prevent
the mixing drum from moving when the mixer is positioned
in an upright position.
10. DO NOT tilt the mixer on a wet, smooth or slippery surface.
11. Once the stand has been assembled, and the locking clip has
been secured, begin tilting the mixer to an upright position.
Remember always tilt from the front of the mixer as shown
in Figure 14.
Figure 12. Frame Locking Clip
Figure 13. Slippery or Wet Surfaces
Figure 14. Tilting Mixer to Upright Position