Assembly And Adjustments - DeWalt DWH200D Instruction Manual

This dust extraction system will fit most D
cordless SDS Plus rotary hammers, corded hammer drills
and premium cordless drill/driver/hammer drills.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
The dust extraction system is an attachment for use with
professional power tools.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.

ASSEMBLY AND ADJUSTMENTS


WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Attaching the Ring Adapter (Fig. A, B)
Your dust extraction system comes with two adapters;
a metal ring adapter with hinge for SDS Plus rotary
hammers 15 and a plastic ring adapter for percussion
hammerdrills 16 .
Refer to the Fitment Guide chart for proper adapter use.
nOTE: If the diameter of the tool's collar is 54 mm, no ring
adapter is needed.
1. If a ring adapter is needed, choose the correct ring
adapter for your tool.
2. Open the ring adapter and slide it onto the tool's
collar 19 as shown in Figure B.
nOTE: The adapter will slide back and forth on the tool.
Fig. B
WALT corded and
e
19
15
16 19
FITMENT GUIDE
No adapter collar needed
Toothed adapter needed
Smooth adapter needed
Assembling the Dust Extraction System
(Fig. A, C–E)
The standard SDS Plus tool holder adapter (short)
comes attached to some tools. But if your tool requires the
Quick Change Chuck (QCC) SDS Plus tool holder adapter
(long) 13 , assemble as follows.
1. Remove the cross head screw from the short adapter
using a cross head screwdriver (Fig. C). Then use the
screw to assemble the long tool holder adapter
(Fig. D) to the dust brush body
2. Carefully slide the newly assembled dust brush and
tool holder adapter into the slot on the top of the side
handle assembly until you hear a click (Fig. E).
Fig. C
18
Fig. D
13
Attaching the Dust Extraction System to
the Tool (Fig. A, F)
1. Slide the assembled dust extraction system onto
the nose of the tool through the ring opening
past the tool holder and sleeve and onto the tool's
collar 19 . If a ring adapter is needed, refer to Attaching
the Ring Adapter.
English
D25333, DCH293, D25263, DCH263,
DCH273, D25262, D25323, DCH253,
DCH213, D25223, D25213, D25123
DCH133, D25133, D25260, D25052,
D25012, D25023, DWD525, DWD520
DCD950, DCD970, DCD985, DCD995,
DCD996, DCD997
14
14
13
18
. Tighten securely.
14
2 ,
3