DeWalt DWH200D Instruction Manual page 6

English
Fig. E
13
7
Fig. F
2. Rotate the dust extraction system to the desired
position on the tool.
3. Lock the assembly in place by securely tightening the
side handle 1 , rotating the grip clockwise firmly so
that the assembly will not rotate due to the torque of
the tool.
4. Install and adjust the depth adjustment rod to
desired length.
Attaching and Removing the Bellows
(Fig. A, G)
Your dust extraction system comes with a short bellow
a long bellow , and a stop bit bellow
5
chart below for proper usage for each bellow.
BELLOW USAGE
Short bellow To be used with 6" (152 mm) overall length
[4" (102 mm) useable] bits.
Long bellow To be used with 10" (254 mm) overall length
[8" (203 mm) useable] bits.
Stop bit bellow To be used with SDS Plus rotary hammer stop bits.
4
2
Attaching the Bellow
You can attach the bellow with the bit either installed
or removed.
1. Push the bellow onto the end of the dust extraction unit
2. Place the wear ring
Removing the Bellow
To remove the bellow, twist and pull the bellow away from
the dust extraction unit.
10 ,
. Refer to the
11
9
1
while using a twisting motion until the bellow is secure.
4 on the oppposite end of
the bellow, closest to the work piece.
1
19