Storage Procedure - Kohler 48RCLB Operation

4.9 Storage Procedure

WARNING
Hot engine and exhaust system.
Can cause severe injury or death.
Do not work on the generator set until
it cools.
DANGER
Hazardous voltage. Moving parts.
Will cause severe injury or death.
Operate the generator set only when
all guards and electrical enclosures
are in place.
Follow the procedure below when storing your
generator set for a long period (3 months or more).
1. Start and run the generator set until it reaches
operating temperature or about 15 minutes.
2. Stop the generator set.
3. Change the oil and oil filter; see Section 4.3.4, Oil
and Filter Change.
4. Check the engine coolant protection; see
Section 4.6.
Note: Use antifreeze capable of withstanding the
lowest possible temperatures.
62 Section 4 Scheduled Maintenance
5. Keep spark plugs in their holes or seal spark plug
holes with suitable threaded metal plugs.
6. Clean the exterior of the generator set and spread
a light film of oil or silicon spray over any exposed
surfaces that may be subject to rust or corrosion.
7. Seal the air inlet, exhaust pipe, and fuel tank cap
with tape.
8. Disconnect and remove the battery. Place the
battery in a warm, dry location for the storage
period. Recharge the battery once a month to
maintain a full charge.
9. Select a well-ventilated (not humid or dusty)
location to store the generator.
10. Cover the entire unit with a dust cover.
Note: Run the generator set once a month
whenever possible.
TP-7102 3/20