Typical Installations; Mounting Bracket - Graco EM5 Instructions-Parts List Manual

Typical Installations

Fig. 1 shows a typical hose reel installation. Fig. 2
shows how these dispense valves can be installed on
a console.
CAUTION
Do not use this electronic metered dispense
valve on non-Graco consoles. Such use could
result in the trigger becoming inadvertently
pressed while the dispense valve is stowed.
H
Fig. 1
KEY DESCRIPTION
H Thermal relief kit (required) Part No. 235998
Install downstream from pump.
J Fluid shut-off valve
K Hose
L Hose reel fluid inlet hose
M Hose reel
N Metered dispense valve
4 309142
Installation
The typical installation shown in Fig. 1 is only a guide;
it is not a complete system design. Contact your
Graco distributor for assistance in designing a system
to suit your particular needs.
This dispense valve is not designed for in-line
installation. Do not install with a shut-off valve
on the outlet side of the meter. Such installation
could result in damage to the meter housing
cover.

Mounting Bracket

J
Mounting bracket 196471 is available for resting an
L
EM5 dispense valve on a console. See Fig. 2.
Do not obstruct the trigger of this dispense
valve, and do not set the unit down resting on its
trigger, or it might not stop dispensing.
M
NOTE: When using the EM5 with the rigid oil
extension on a dispense console, the rigid tube (5a)
should be oriented with the 75_ bend closest to the
nozzle, as shown below. This prevents interference
when used with a dispense console.
K
N
mounting
bracket
196471
TI0268
Fig. 2
CAUTION
CAUTION
5a
5a
TI0274