Enterasys SmartSwitch 2200 Management Supplement page 26

Protocol Port Configuration Screen
The following describes the fields of the Protocol Port Configuration screen:
Protocol Information Field (Read-Only)
Displays the classification rule of the line selected in the VLAN Classification Configuration
screen. For example, in
IP) – was selected in the VLAN Classification Configuration screen to access the Protocol Port
Configuration screen. All ports with YES in the Classify columns indicate that they are associated
with VID 1 with an Ether II Type Classification. This will cause Ether II Type of type 0/0800
(DOD IP) frames to be transmitted out all ports set to YES as frames belonging to VLAN 1.
Port (Read-Only)
Displays the number of each port.
Classify (Toggle)
Toggles between YES and NO, which determines whether or not the associated port is set to the
classification rule shown in the Protocol Information field (see
without brackets, it indicates that the associated port does not support classification and will not
toggle to YES. An example of such a port is the host port.
NOTE: As each Classify field is highlighted, the Event Message Line (not shown) at the
top of the screen indicates the port type. For example: Fast Ethernet Front Panel, FTM
Backplane Port 3, and Gigabit Ethernet VHSIM.
For details about assigning ports to a classification rule, refer to
SET ALL PORTS (Toggle)
Toggles between YES and NO. This determines whether or not all ports will be assigned to the
classification rule in the Protocol Information field. NO is the default. For details about setting all
ports simultaneously, refer to
SET PORTS TO VLAN FORWARDING (Toggle)
Used to add the port(s) set to YES in the Classify column to the VLAN Forwarding List of the
VLAN shown in the Protocol Information field.
NOTE: The ports can only be added to the VLAN Forwarding List of an existing VLAN.
If the VLAN does not exist, it must be created before the ports can be assigned to the
VLAN Forwarding List.
2-14 Local Management Screens
Figure 2-4, the classification rule – VID 1, Ether II Type, 0x0800 (DOD
Section 2.4.1
Figure 2-4). If NO is displayed
Section 2.4.1.