Model C1025
Battery Charger
Location
Cleaning the Contacts
Batteries
Care, Handling and
Storage
Battery Voltage Low
Tone
Charging Batteries
© 3M 2006
The battery charger should be placed on a flat surface such as a desktop
or table in a clean, dry environment, or an optional wall mount unit may
be used.
If the indicators fail to light during charger operation, clean the contacts
using an alcohol-moistened cotton swab.
Avoid dropping batteries. Do not carry batteries in your pockets or
leave them in hot, damp or dirty places.
Be careful not to short the battery contacts together.
When the battery voltage becomes too low, a short, low-volume tone
sounds in the headset at seven-second intervals to alert the operator to
replace with a fully charged battery.
The "battery voltage low tone" continues for two minutes after which
the headset turns off automatically to prevent damage to the batteries.
To charge a battery, insert the battery in one of the charging slots as
shown in Figure 13.
•
The indicator lights RED to indicate the battery is charging.
•
The indicator lights GREEN to indicate the battery is fully charged.
•
The indicator lights ORANGE to indicate the battery is defective.
Discharged batteries require 1-1/2 to 2 hours to charge.
Caution
!
Note
Figure 13.
Maintenance
15