Toshiba BU Series Instruction Manual page 60

● Setting
- Set the width of Timer0Active pulse
Set the following value to "TimerDuration" register. Setting value is Float type.
- Set the delay of Timer0Active pulse
Set the following value to "TimerDelay" register. Setting value is Float type.
- Select the source of Timer0Active pulse to start
Select the following value to "TimerTriggerSource" register. Setting value is Enumeration type.
TimerTriggerSource
ExposureStart (*)
● Note
"TimerTriggerSource" operation is as follows,
Line0Active is available in HardwareTrigger mode, and to be responsed at FrameTriggerError.
FrameTrigger is available in both HardwareTrigger and Software Trigger mode, and not to be responsed at
FrameTriggerError.
ExposureStart is available in both HardwareTrigger and Software Trigger mode, and not to be responsed at
FrameTriggerError. Timer0Active pulse delays TiggerDelay+TimerDelay[us].
Copyright © 2016 – 2019 Toshiba Teli Corporation, All rights reserved.
TimerDuration
Minimun (*)
Maximum
TimerDelay
Minimun (*)
Maximum
Off Disables the timer trigger.
Line0Active Starts when Line0 is active.
Starts with the reception of the Exposure Start
FrameTrigger Starts with the reception of the Frame Start Trigger.
Pulse width
0.00[μs]
2000000.00[μs]
* initial factory setting
Delay value
0.00[μs]
2000000.00[μs]
* initial factory setting
Description
* initial factory setting
59 / 80
http://www.toshiba-teli.co.jp/en/index.htm
D4256843D
xB