Advertisement
TROUBLE SHOOTING
PROBLEM
CAUSE
Excessive dust in
Exhaust vent is plugged or air
cabinet.
flow is blocked.
Abrasive media worn.
Too mush abrasive media
inside cabinet.
Loose
air
line
connections.
Uneven blasting
Too mush abrasive media
actions.
inside cabinet.
Moisture present inside the
cabinet.
Inadequate speed
Abrasive media worn.
or ineffeciency of
blast.
Pressure is too low.
Static electricity.
Dry weather conditions.
PARTS DIAGRAM & PARTS LISTS
Refer to the Parts section of the King Canada web site for the most updated parts
diagram and parts list.
REMEDY
Clean rear vent and keep vent
away from the wall.
Replace abrasive media.
Remove excess media.
or
fitting
Tighten fittings and make sure
air lines are secure.
Remove the excess media.
Check air line to make sure
there is no moisture in it.
Replace abrasive media.
Increase inlet pressure and
make sure the control valve is
fully opened.
Leave the item being cleaned
on the grating.
ERRATUM 2009
KSB-110N-9 NEW GUN AND NOZZLES
As of 2009, this Sandblast Cabinet now comes with a new gun and nozzles. To obtain a
replacement gun and/or nozzles for this Sandblast Cabinet model KSB-110N-9, please
use the following King Canada accessory model numbers;
Mod. KM-035
Replacement gun
Mod. KM-036
Replacement Nozzles (4pc. kit)
Advertisement
