Advertisement
ASSEMBLING THE KSB-350
SAND BLAST CABINET
Any sand blast cabinet will produce a powerful flow of abrasive particles. To avoid
personal injury and property damage, read and understand this manual before
assembling, operating or servicing. Failure to follow these instructions could result in
operator injury as well as void the sand blasting system.
Your KSB-350 vertical sand blast cabinet is designed for cleaning, polishing and
finishing with dry abrasives ONLY, such as sand, glass bead or plastic granule
abrasives. The finishes can vary from coarse to fine according to the sizing of the glass
bead or sand. On delicate parts, start out with minimal air pressure to avoid
unnecessary peening or undesired, excessive abrasion. Abrasive media is very
slippery and should be cleaned up immediately to avoid possible operator injury.
KSB-350 ASSEMBLY INSTRUCTIONS
1) Fasten the four leg supports to the four
legs of the stand. Mount nuts on the
inside of the legs.
2) Fasten frame #36 and the four legs with
screws and nuts.
3) Fasten shelf to the holes in the middle of
the legs with screws, washers and nuts.
4) Place the funnel, foam tape, net frame
and net in this order on top of the stand
assembly and fasten with screws,
washers and nuts. Punching holes
through the foam tape will be necessary.
ASSEMBLING AND OPERATING
THE KSB-350 SAND BLAST CABINET
5) Connect the air input pipe #28 and the
hose #31 to the sand input at the bottom
of the sanding gun. The connector
below the gun handle is the air input.
The air input hose must be supplied by
the operator. The outer diameter of the
hose is 5/8", enter the air input hose
throught the protective ring #25 at the
front of the cabinet and connect to the
gun.
6) The user can connect a vacuum to the
flange and dust outlet located at the rear
of the cabinet. Install dust outlet, this
will allow you to reduce the amount of
dust generated in the cabinet while you
work.
7) Insert power adaptor (#49) into socket
(#50) located at the rear of the cabinet
and plug power adaptor to a standard
110V outlet.
OPERATING THE KSB-350
IMPORTANT!
• Close and latch the doors at all times prior to operating the sand blast cabinet.
• Clean up all spills, sand particles are very slippery.
• When using your sand blast cabinet, a 5 HP compressor is recommended. A fine
grade of abrasive is recommended to prevent clogging.
A) Select the apropriate nozzle for your needs. The sand input hose feeds from the
sand input pipe and is attached to the front of the gun. The air input is attached to
the base of the gun. This part of the gun is fitted with 1/4" threads which will fit
most air hoses. At the front side of the cabinet is the opening for the air input hose
from your compressor. Connect your hose to the bottom handle of the gun.
Advertisement
