Advertisement
ASSEMBLINGTHE KSB-110N
SAND BLAST CABINET
Step 4.
Install the light clamps (13) as
illustated.
Step 5.
Assemble the filter.
Step 6.
Push the fluorescent light (39) forward
into the light clamps, then put the
electric cord outside the hole through
panel 11, use screw nut (38) which is
enclosed on the cord to secure, then
combine with the circuit inside the
wire connection box (44) and tighten
on panel 11.
Step 7.
Assemble the blast gun.
Step 8.
Once these steps have been completed,
you must now assemble the lid
assembly (1), but first, assemble the lid
hinges (7) with the screws (6) to the
top of the rear panel (9).
ASSEMBLING AND OPERATING
THE KSB-110N SAND BLAST CABINET
Step 9.
Once the hinges are assembled, place
the lid under the two hinges.
Assemble the front locking knob (2)
and lock into position. Now secure the
lid to the hinges with the screws (6),
(you must apply pressure to the lid).
Step 10.
Open the top lid and connect the
positioning chain with a screw and
nut at each end as illustrated.
OPERATION INSTRUCTIONS
(KSB-110N)
Place the sand blast cabinet system near
a 115V/60Hz AC electrical outlet. Make
sure to check if the power source is
adequate for use with this sand blast cabinet. An electrician should be consulted if
the proper outlet is not available or if the user has any questions about the
condition of their electrical circuit.
Attach the air supply line from a compressor capable of maintaining 5 CFM at 80psi
to the inlet connection found on the right side of the cabinet. Because of the
variation in air supply systems, the air inlet coupling is not provided. Use the
particular fitting that is compatible with your air supply system. *DO NOT
OPERATE THE KSB-110N SAND BLAST CABINET AT OVER 100 PSI.
Check the air supply line fittings and hose attachments to the rear of the gun. Also
make sure the media supply hose is attached tightly on the nipple on the underside
of the gun. Place no more than 10 pounds of abrasive media into the center of the
cabinet. Excessive amounts will create clouded cabinet conditions, blow-by of
media through the exhaust, or sluggish and ineffective blasting performance. With
the air supply connected, if all the fittings and the joints are not leaking and the unit
is plugged in, you are ready to test the sand blast cabinet. Follow the startup
operation steps below.
-Place the part into the cabinet. Always close and latch the lid after placing the part
in the cabinet prior to blasting. Severe injury to the skin and eyes may result from
exposure to the blast stream.
- After putting your hands into the gloves, grasp the gun and depress the trigger.
This should begin the blasting flow. If no flow is seen, you may need to clear the
tube by covering the gun nozzle momentarily.
-Now you may begin blasting the part. You should move the blast stream
continuously over the part in an even and circular motion. The flow should not be
too hard or concentrated to avoid undesirable peening.
Advertisement
