Advertisement
GENERAL SAFETY INSTRUCTIONS
FOR POWER TOOLS
1. KNOW YOUR TOOL
Read and understand the owners
manual and labels affixed to the tool.
Learn its application and
limitations
as well as its specific potential hazards.
2. GROUND THE TOOL.
This tool is equipped with an
approved 3-conductor cord and a
3-prong grounding type plug to fit
the
proper
grounding
type
receptacle. The green conductor in
the cord is the grounding wire.
NEVER connect the green wire to a
live terminal.
3. KEEP GUARDS IN PLACE.
Keep
in
good
working
order,
properly adjusted and aligned.
4. REMOVE ADJUSTING KEYS AND
WRENCHES.
Form habit of checking to see that keys
and adjusting wrenches are removed
from tool before turning it on.
5. KEEP WORK AREA CLEAN.
Cluttered areas and benches invite
accidents. Make sure the floor is
clean and not slippery due to wax
and sawdust build-up.
6. AVOID DANGEROUS ENVIRON-
MENT.
Don't use power tools in damp or
wet locations or expose them to rain.
Keep work area well lit and provide
adequate surrounding work space.
7. KEEP CHILDREN AWAY.
All visitors should be kept a safe
distance from work area.
8.
MAKE
WORKSHOP
CHILD-
PROOF.
-with padlocks, master switches or
by removing starter keys.
9. WEAR PROPER APPAREL.
Do not wear loose clothing, gloves,
neckties or jewelry (rings, watch)
because they could get caught in
moving parts. Non-slip footwear is
recommended. Wear protective hair
covering to contain long hair. Roll up
long sleeves above the elbows.
10. ALWAYS WEAR SAFETY GLASSES.
Always wear safety glasses (ANSI
Z87.1). Everyday eyeglasses only
have impact resistant lenses, they are
NOT safety glasses. Also use a face
or dust mask if cutting operation is
dusty.
11. AVOID ACCIDENTAL STARTING.
Make sure the swich is in the ''OFF''
position before plugging in.
ASSEMBLING THE KSB-110N
SAND BLAST CABINET
Any sand blast cabinet will produce a powerful flow of abrasive particles. To avoid
personal injury and property damage, read and understand this manual before
assembling, operating or servicing. Failure to follow these instructions could result in
operator injury as well as void the sand blasting system.
Your KSB-110N sand blast cabinet is designed for cleaning, polishing and finishing
with dry abrasives ONLY, such as glass bead or plastic granule abrasives. The finishes
can vary from coarse to fine according to the sizing of the glass bead. On delicate
parts, start out with minimal air pressure to avoid unnecessary peening or undesired,
excessive abrasion. Abrasive media is very slippery and should be cleaned up
immediately to avoid possible operator injury.
KSB-110N ASSEMBLY INSTRUCTIONS
Step 1.
Connect the front panel (8), rear panel
(9), right panel (10), left panel (11)
with the screws supplied.
Step 2.
Fix the cabinet to the base (12) and the
four legs (14 & 15), then place the
screen (32) into the cabinet.
Step 3.
Secure the glove (31) with the glove
clamp (30) onto the front panel as
illustrated.
Advertisement
