Function Of Operational Buttons - JUKI HZL-F Series Instruction Manual

Function of operational buttons

Needle up/down button
When machine stops, press this button to change the needle position.
(When the needle is up, the needle moves down and vise versa.)
* when a stitch pattern is not selected, needle does not move
downward but you can move the needle up.
Even when the presser foot is raised, be aware that the
needle moves up or downward.
Thread trimming button
After sewing, press this button to trim
both threads automatically.
Notes for thread trimming:
1. Do not use thread thicker than No.30.
2. After trimming, the stitch can be done without pulling up bobbin thread.
3. When sewing again after thread trimming, if you pull up the bobbin
thread again and place it underneath the presser foot together with
needle thread, you can avoid birds nest on the wrong side of the fabric.
4. Regularly clean the machine (refer to page 121), as dust in the area of
the thread trimming unit may cause malfunction.
8
Speed controller
While sewing, speed can be
adjusted.
Start/stop button
When pressing this button, machine starts to sew slowly and then up to the speed set by speed
controller. When pressing this button again, machine stops with needle at its down position. Color of
button indicates machine status.
Green: Ready to start and/or while sewing
Red: Not ready to start (When it is pushed in red condition, needle moves by one stitch.)
Reverse stitch button
While pressing this button, machine
sews reverse (lock stitch).