Table of Contents
Advertisement
Faults and what to do about them
en
3
Faults and what to do
about them
E mergency release
F a u l t s a n d w h a t t o d o a b o u t t h e m
E.g. power outage or in the event of a
loss of power
The programme continues when the
power supply is restored.
However, if the laundry has to be
removed, the appliance door can be
opened as follows:
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with hot water
and laundry.
If possible, leave it to cool down first.
:
Warning
Risk of injury!
Reaching into the drum while it is still
turning may cause hand injuries.
Do not reach into the drum when it is
turning.
Wait until the drum has stopped turning.
Information on the display panel
Display
Õ
•©£
46
Cause/Remedy
Flashes fast + signal: The door was opened and the water level is too high.
■
Close the door, continue the programme with Inicio/Pausa + Carga (Start/
Reload) button or select [ (Drain).
Flashes slowly: The door lock temperature is too high to open the door. Wait
■
approx. 30 seconds until the door lock temperature cools down.
The temperature in the drum is too high. Wait for the appliance running to cool
down the laundry till the •©£ disappears on the display panel, then the door can
be opened.
Caution!
Water damage!
Any escaping water may cause water
damage.
Do not open the door if water can be
seen through the glass.
Turn the programme selector to
1.
Û (Off). Pull out the mains plug.
Open the service flap.
2.
Drain the water. ~ Page 43
3.
Pull the emergency release
4.
downwards with a tool and release.
The door can then be opened.
Advertisement
Table of Contents
