Table of Contents
Advertisement
Display
r
E lights up
The symbol Û
flashes
E:36
alternating with
-10
E:35
alternating with
-10 (Suitable for spe-
cial models)
H:95
alternating with
"Ÿš
when programme is
finished
H:32
alternating with
"Ÿš
when programme is
finished
Other displays
Cause/Remedy
Flashes (no water supply): Water tap turned on? Filter in the water supply is
■
blocked? ~ "Filter in the water supply is blocked" on page 45
Is the supply hose kinked or trapped?
Lights up (low water pressure): For information only. This will not affect the
■
programme progress. The programme duration is extended.
The childproof lock is activated – deactivate it.
Run the i Algodón/Algodão 90°C (Cottons 90°C) programme to clean and
care for the drum and the outer tub.
Notes
Run the programme without laundry.
■
Use washing powder or a detergent containing bleach. To prevent foaming,
■
only use half the amount of detergent recommended by the detergent manu-
facturer. Do not use detergent designed for woollens or delicates.
Switching the drum care information signal on/off. ~ Page 41
■
Drain pipe or water drain hose is blocked. Clean the drain pipe and the water
■
outlet hose.
Drain pipe or water drain hose is caught or jammed. Ensure that the drain pipe
■
and water drain hose are not kinked or trapped.
The drain pump is blocked.
■
~ "Drain pump is blocked" on page 43
The drain hose at the siphon is blocked.
■
~ "The drain hose at the siphon is blocked" on page 44
The water drain hose is connected too high. Install the water outlet hose at a
■
maximum height of 1 meter.
~ Page 16
There is water in the base trough, the appliance is leaking. Turn off the tap. Call
customer services.
No water detected in drying phase, may get bad drying result.
~ "Filter in the water supply is blocked" on page 45
The unbalanced load detection system has interrupted the spin cycle because the
laundry is unevenly distributed. Distribute small and large items of laundry evenly in
the drum.
Turn the programme selector to Û (Off), wait for five seconds and then switch it on
again. If the display appears again, call customer services.
Faults and what to do about them
en
47
Advertisement
Table of Contents
