Table of Contents
Advertisement
Positioning and connecting
en
Before washing for the first
time
The appliance was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
i Algodón/Algodão 90°C (Cottons
90°C) programme the first time without
laundry.
Note:
The appliance must have been
■
installed and connected properly.
~ "Positioning and connecting"
on page 13
Never switch on a damaged
■
appliance.
Insert mains plug.
1.
Turn the water tap on.
2.
Close the door. Do not load any
3.
laundry.
Select the i Algodón/Algodão
4.
90°C (Cottons 90°C) programme.
Open the detergent drawer.
5.
Pour approx. 1 litre of water into
6.
Dispenser II.
Add standard detergent to
7.
Dispenser II according
to manufacturer's instructions for
light soiling.
To prevent frothing, use only
Note:
half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
Close the detergent drawer.
8.
Select Inicio/Pausa + Carga (Start/
9.
Reload) .
When the programme ends, turn the
10.
programme selector to Û (Off).
Your appliance is now ready for use.
20
Transportation
e.g. when moving home
Preparatory work:
Turn off the water tap.
1.
Reduce the water pressure in the
2.
supply hose. ~ Page 45
Drain any residual water.
3.
~ Page 43
Disconnect the appliance from the
4.
mains.
Remove the hoses.
5.
Empty the dispensers.
6.
Caution!
Risk of damage to the appliance
caused by detergent/fabric softener
leaking from the dispensers
Leaking detergent/fabric softener
can prevent the appliance from
working correctly, e.g. due to
damage to the electronics.
Empty the dispensers before
transporting the appliance.
Installing the transport locks:
Remove the covers and keep them
1.
in a safe place.
Use a screwdriver if
Note:
necessary.
Advertisement
Table of Contents
