Onkyo TX-NR787 Instruction Manual page 84

Playing Back
Contents Connections
≫
Set the remote controller to the ZONE control mode (ZONE 2/ZONE 3)
( p82, 83), and then perform the following operations.
1. Point the remote controller at the unit, and press .
• "Z2" or "Z3" on the display of the main unit lights up.
• ZONE 3 cannot be turned ON unless "2. Speaker" - "Configuration" - "Zone
Speaker" in the Setup menu (
2. Press the input selector of the input source you want to play in the separate room.
To control on the main unit, press ZONE 2 button or ZONE 3 button, and then within
8 seconds, press the input selector button of the input to be played in the separate
room. To play the same source in the main room and separate room, press ZONE 2
button or ZONE 3 button of the main unit twice.
3. When using the ZONE 2 LINE OUT connection, adjust the sound volume on the
pre-main amplifier in the separate room. As for the ZONE speaker output, adjust
the volume on the remote controller. To do this on the main unit, press ZONE 2
button or ZONE 3 button, and then within 8 seconds, adjust the volume using
the MASTER VOLUME dial.
• If you turn the unit to standby during multi-zone playback, the Z2 or Z3
indicator is dimmed, and the playback mode is switched to playback in a
separate room only. Setting ZONE 2/ZONE 3 to on while the unit is in standby
also switches the playback mode to playback in a separate room only.
• For ZONE 2 output, audio from externally connected AV components can
be output only when it is an analog or 2ch PCM audio signal. When the AV
component is connected to this unit with a digital coaxial cable or digital optical
cable, change the audio output of the AV component to the PCM output.
• For ZONE 3 output, audio from externally connected AV components can be
output only when it is an analog audio signal.
• DSD and Dolby TrueHD audio signals cannot be output to ZONE 2/ZONE 3
when selected with the "NET" input selector.
• If ZONE 2/ZONE 3 is on, power consumption during standby will increase.
To set the function to off:
control mode.
84
Front Panel≫ Rear Panel≫ Remote≫
Playback
≫
p113) is not set to "Zone 2/Zone 3".
Press while the remote controller is in the ZONE
Setup
≫ ≫