Onkyo TX-NR787 Instruction Manual page 127

„ 5. 12V Trigger
Set when outputting the control signal (maximum 12 V/100 mA) through the 12V
TRIGGER OUT jack. You can enable power link operation when you connect the
unit and the external devices equipped with 12V trigger input jack.
Setting Item Default Value
Zone Main
6. Multi Zone
„ 1. Zone 2
Change the settings for Zone 2.
Setting Item Default Value
Maximum Volume Off
Power On Volume Last
Setting Details
Set which zone to output the 12V trigger when
playing. If you select "All", then the 12V trigger is
output to all zones that are playing.
Setting Details
Set the maximum value for Zone 2 to prevent the
volume from becoming too loud. Select a value
from "Off", and "50" to "99".
(When "3. Audio Adjust" - "Volume" - "Volume
Display" is set to "Absolute")
Set the Zone 2 volume level of when the unit is
turned on. Select a value from "Last" (Volume level
when the unit was turned off), "Min", "0.5" to "99.5"
and "Max". (When "3. Audio Adjust" - "Volume" -
"Volume Display" is set to "Absolute")
• You cannot set a higher value than that of
"Maximum Volume".
Contents Connections
≫
„ 2. Zone 3
Change the settings for Zone 3.
Setting Item Default Value
Maximum Volume Off
Power On Volume Last
„ 3. Remote Play Zone
Change the settings for remote play.
Setting Item Default Value
Remote Play Auto
Zone
127
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
Set the maximum value for Zone 3 to prevent the
volume from becoming too loud. Select a value
from "Off", and "50" to "99".
(When "3. Audio Adjust" - "Volume" - "Volume
Display" is set to "Absolute")
Set the Zone 3 volume level of when the unit is
turned on. Select a value from "Last" (Volume level
when the unit was turned off), "Min", "0.5" to "99.5"
and "Max". (When "3. Audio Adjust" - "Volume" -
"Volume Display" is set to "Absolute")
• You cannot set a higher value than that of
"Maximum Volume".
Setting Details
When playing with AirPlay or Spotify Connect,
or when using the Music Server function to play
remotely from your PC, you can set whether to play
in the main room (where this unit is located) or in a
separate room (ZONE 2/ZONE 3).
"Auto": When the main room input is NET, music
is played in the main room. When the separate
room input is NET and the main room input is other
than NET, then the music is played in the separate
room.
"Main", "Zone 2", "Zone 3": Select when limiting the
play zone to a particular room. For example, when
playing only in the separate room, select "Zone 2"
or "Zone 3".
• This function may not work if playback is already
proceeding with the same network function.
≫