Samsung ProXpress C3060 Series Service Manual page 114

4. Troubleshooting
•
Service Functions > SFE
Special Feature Enablement (SFE) means to provide the configurable options (On/Off) in service mode for technicians
or dealers to satisfy the requirements from B2B sites easily without changing the firmware installed in a device.
SFE Description
Code
001 In case of printing in directional media (Letterhead/Preprinted/Punched), the device prints as the same output
direction regardless of simplex or duplex.
002 The device always prints output as mono about PC printing.
007 The device prints as original 1 dot line without 2 dot line compensation.
008 The device ignores paper size command in PRN and prints as paper size in tray.
009 PJL readback response is changed with HPOS.
1) Add <CR><LF> to EOJ response.
2) No EOJ job but EOJ response occurs.
3) Device uses Job name instead of EOJ name.
010 Maximum value of 'Power save time' is increased as 240 min.
012 If the device is in jam status, all print jobs except secure or stored jobs are deleted automatically.
013 The device ignores the USB memory stick and detects only card reader.
014 When the authenticated user uses scan to email, user's email address is added automatically.
019 User ID is not case-sensitive for login
024 The device executes copy job as only mono even though color copy is started.
032 If this SFE option is enabled, the image processor shall not omit line that is less than 1 dot. By PCL 6 command
rule, the device shall not print less than 1 dot line. But this SFE is enabled, the device shall print it.
033 If this SFE option is enabled, the image processor shall draw Letter Gothic font as previous thickness(Bitstream)
thicker than URW++.
035 The device shall provide auto scale for A3/Leger to A4/Letter in case of A4 Models that doesn't support
A3/Ledger size.
037 The device shall permit or ignore host printing job by permit key PJL command from solution such as IPRINT.
•
Service Functions > Envelope Rotate
This menu is enabling rotate when printing on envelope. The machine usually guides to load envelope with SEF
direction. If this function is enabled, the user can load envelope with LEF direction and the machine shall rotate image
for printing exactly on envelope.
This function shall provide the setting options as follows:
-
Off (default) : Load envelope SEF direction
-
90 degrees : Load envelope LEF direction
-
180 degrees : Load envelope SEF direction with flap is bottom side
4-38 Copyright© 1995-2017 SAMSUNG. All rights reserved.