King Canada KC-1401FX Instruction Manual page 6

INSTALLING THE PULLEY GUARD
Place the pulley guard (A) Fig.7 over the pulleys and fix it to the stand top using small
pan hd screws, washers and hex. nuts.
INSTALLING UPPER & LOWER GUIDE BLOCK ASSEMBLIES
1. LOWER GUIDE. Locate the protective plate (A) Fig.8 and the lower guide block
assembly (B), install them to the frame as shown using two small hex. bolts and
washers. Do not fully tighten the hex. bolts at this point, to allow for adjustment
later. Adjustment of the guide blocks and bearings will be necessary after the blade
is installed, tensioned and tracking properly.
2. UPPER GUIDE. Locate the upper guide block assembly (A) Fig.9. Slide the
assembly onto the guide post (B) as shown and secure it in place by tightening
hex. bolt (C). Again, it will be necessary to fine tune the guide blocks and bearings
after the blade is installed, tensioned and tracking properly.
3. Fix the blade guard (D) to the side of the upper blade guide assembly, loosen the
two hex. bolts (E), slide the blade guard under the washers and tighten hex. bolts.
INSTALLING THE DUST CHUTE
Remove the lower blade guard cover (C) Fig.8 and install the dust chute (D) to it
using two flange hd screws. Reinstall the lower blade guard cover. Your dust chute
should now be just as shown in Fig.8.
ASSEMBLY
FIGURE 7
FIGURE 8
FIGURE 9