Related Manuals for King Canada KC-3010
Summary of Contents for King Canada KC-3010
-
Page 1: Instruction Manual
10” SLIDING TILE SAW WITH LASER GUIDE • Enhanced laser effect MODEL: KC-3010 INSTRUCTION MANUAL COPYRIGHT © 2005 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC. - Page 2 Warranty does not apply to defects due directly or indirectly to misuse, abuse, negligence or accidents, repairs or alterations and lack of maintenance. KING CANADA shall in no event be liable for death, injuries to persons or property or for incidental, special or consequential damages arising from the use of our products.
-
Page 3: General Safety Instructions
GENERAL SAFETY INSTRUCTIONS VOLTAGE WARNING: Before connecting the tool to a power source (receptacle, outlet, etc.) be sure the voltage supplied is the same as that specified on the nameplate of the tool. A power source with voltage greater than that for the specified tool can result in SERIOUS INJURY to the user - as well as damage to the tool. -
Page 4: Additional Safety Instructions
14. Keep your work space clear and free of all debris. 15. Keep the tile cutter clean and maintained to achieve the safest and highest performance for each job. KEEP THESE SAFETY RULES FOR FUTURE REFERENCE TILE SAW SPECIFICATIONS Model ......................................KC-3010 Voltage ......................................120V Horsepower ....................................2.5 HP Amperage ....................................15 Amp. -
Page 5: Electrical Connections
ELECTRICAL CONNECTIONS WARNING! ALL ELECTRICAL CONNECTIONS MUST BE DONE BY A QUALIFIED ELECTRICIAN. FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY! ALL ADJUSTMENTS OR REPAIRS MUST BE DONE WITH THE TILE SAW DISCONNECTED FROM THE POWER SOURCE. FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY! POWER SUPPLY 120V GROUNDED OUTLET WARNING: YOUR TILE SAW MUST BE CONNECTED TO A 120V,... - Page 6 ASSEMBLY UNPACKING, ASSEMBLY & SET UP Caution: Follow all of the assembly & installation instructions completely before connecting the tile saw to a power source or turning the motor on. Carefully open the main box and the stand box and remove all the saw components and packing materials.
-
Page 7: Operation
OPERATION Once your sliding tile saw is completely assembled, we suggest to get the water tray and laser guide set up properly before attempting to operate. WATER PUMP/WATER SUPPLY Warning! To prevent excessive wear on the blade, make sure to maintain a continuous flow of water on the blade during all operations. - Page 8 OPERATION/MAINTENANCE Cutting Tiles: 1. Place the marked tile on the table and brace it against the rear of the table. Turn on laser guide and align the cut mark with the laser beam. 2. Once the tile saw has been turned on, allow the blade to speed up to full speed. Make sure that the pump is supplying a continuous flow of water to the blade.