Local Setting Procedure - Fujitsu ASTG30KMTC Service Manual

2-2. Local setting procedure

NOTE: Before performing the function setting, be sure to stop the operation of the air conditioner.
¢ Low noise mode
1. Press the MODE switch button (SW1) for 3 seconds or more to switch to "Local setting mode".
2. After confirming the LED lamp of POWER/MODE blinks 9 times, press the ENTER switch but-
ton (SW3).
3. Press the SELECT switch button (SW2), and adjust the LED lamp as shown below. Then the
LED lamp indicates the current setting.
4. Press the ENTER switch button (SW3).
5. Press the SELECT switch button (SW2), and adjust the LED lamps as shown below.
2-2. Local setting procedure
LED lamps
(1) (2) (3) (4)
SW1 SW2 SW3
Switch buttons
PUMP
POWER
LOW NOISE
DOWN
ERROR
MODE
(L1) (L2)
Blinks
)
(9 times
Sign " ": Lights off
LOW NOISE
MODE
LOW NOISE
E
MOD
MODE 1: Low
MODE 2: Lower
- (05-12) -
(5)
SW4 SW5
PEAK CUT
(L3) (L4) (L5) (L6)
LOW NOISE
(L2) (L3)
Blink
LOW NOISE
(L2) (L3)
Sign " ": Lights on
PEAK CUT
(L4) (L5) (L6)
Blink
Blink
2. Function settings (For outdoor unit: AOTG34KMTC only)