Advertisement
7.
Install both grass bag assemblies, with the tight mesh sides
facing forward, onto the bag support brackets by inserting
the front edge in first, as shown in 1 of Figure 4-13, and
setting the back edge down(2) until it fits into the assembly.
1
Figure 4-13
Install the Deck Chute Elbow
Determine if your deck is a newer model, or an older model.
Refer to (1) in Figure 4-14. If your deck has a mounting stud
present, then you have a newer deck model and you should refer
to the instructions that follow. If no stud is present, refer to the
instructions titled On Tractors With Older Deck Configurations
later in this section.
1.
Place deck into the lowest cutting position.
2.
If present, remove the protective cap off of the mounting
stud on the mowing deck as shown in (1) of Figure 4-14.
3.
With the tractor's discharge chute raised up and held open (2),
install the chute elbow by placing the chute elbow mounting
pin into the hole provided (3), as shown in Figure 4-14.
1
Figure 4-14
2
2
3
4.
Secure the chute elbow to the deck using the wing knob
720-04122 from hardware pack 689-00318A. See Figure
4-15.
Figure 4-15
IMPORTANT:
Be certain that the bottom of the discharge
chute is positioned inside of the lip of the deck opening, as
shown in Figure 4-16.
Figure 4-16
S
ection
4 — A
& i
SSembly
nStAllAtion
11
Advertisement
