Advertisement
Make sure screen sits under the cover's lip
4.
Install the bagger cover onto the bag support assembly,
as shown in Figure 4-9. The plastic cover goes inside of the
two mounting tabs.
5.
Slide the hinge pin into the hole located on the mounting
tab, as in Figure 4-10. Use the cut-out window (See inset in
Figure 4-10) to line up the hinge pin on the other side and
push pin all the way in until it reaches the end-stop. At this
point the pin clips into place and is secured by a tab in the
bagger cover. See Figure 4-11.
10
S
4 — A
ection
SSembly
Figure 4-8
Figure 4-9
& i
nStAllAtion
Figure 4-10
Figure 4-11
6.
Open Hood by pushing in on the rear, right-side tab with your
right hand, as shown in 1 of Figure 4-12, and lifting the cover
with your left hand in the center rear of the bagger cover, 2.
2
Figure 4-12
1
Advertisement
