Measuring Elapsed Surface Interval; Exiting The Dive Mode; Viewing Diving Log Data; Deleting Diving Log Data - Casio 5624 Operation Manual

Measuring Elapsed Surface
Interval
This function measures the time since your
last dive as surface interval time, which can be
used in preparation for repetitive diving.
Surface interval times up to 24 hours can be
measured.
1.
Enter the Dive Mode.
Navigating Between Modes
l
2.
Use the operations below to perform a
timer operation.
B
Dive 1 start
B
Surface Interval 1 start
(Hold down at least two seconds.)
B
Dive 2 start
B
Surface Interval 2 start
(Hold down at least two seconds.)
Surface interval hours
Surface interval minutes
Surface interval seconds
Surface interval hours (24 hours per rotation)
The second hand moves
●
counterclockwise.

Exiting the Dive Mode

Holding down (C) for at least two seconds in
the Dive Mode enters the Calendar Mode.
If you exit the Dive Mode while dive time or
●
surface interval time measurement is in
progress, the measurement operation will
stop and the watch will enter the Calender
Mode.

Viewing Diving Log Data

You can use OCEANUS Connected to view
dive times and surface interval times
measured with the watch.
You can also use OCEANUS Connected to
input detailed diving information and paste
images into measured data.
Operation Guide 5624
Viewing Log Data
●
Measured log data is transferred to
OCEANUS Connected when the watch is
connected with your phone.
You can use OCEANUS Connected to view
log data for individual diving points you select
on a map or from an area point list.
Viewing and Using Diving Log Data with
l
OCEANUS Connected
Note
After you start a dive time
●
measurement operation and connect
the watch with a phone, information for
your current location will be obtained
and automatically registered in
OCEANUS Connected.
How to Use Log Data
●
In addition to measurement data, you can also
input information about your dive into the
OCEANUS Connected log data.
You can also paste photographs you shot
during your dive into log data to create a
simple diving log book.
Viewing and Using Diving Log Data with
l
OCEANUS Connected
Important!
You can use OCEANUS Connected to
●
view diving log data records. Note that
you cannot view diving log data
records using watch operations.

Deleting Diving Log Data

1.
Enter the Dive Mode.
Navigating Between Modes
l
2.
Loosen the crown and then pull it out to the
first click.
3.
Hold down (B) for at least two seconds.
This will cause the second hand to
perform one revolution and delete the
diving log data.
4.
Push the crown back in and then lock it.

Tide Level

You can use the watch to check the current
tide level in a port that you specify with
OCEANUS Connected.
Important!
Displayed information is intended for
●
reference only. Do not use it for
maritime navigation, etc.
To check a tide level, use OCEANUS
●
Connected to select the port whose
information you want to look up. Tide
level information will not be displayed
in the Tide Graph Mode unless you
have a port specified.
When there is no port specified

Specifying a Port

Use OCEANUS Connected to select the port
whose tide level information you want to view.
Using OCEANUS Connected to Change
l
the Port Setting
Important!
Use OCEANUS Connected to specify
●
a port. Note that you cannot configure
this setting using watch operations.
17