Measuring Elapsed Time; Measuring A Split Time - Casio 3545 Operation Manual

1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Press (D) to scroll through alarm ([1] to [4],
[SNZ]) and hourly time signal ([SIG])
screens until the one you want to configure
is displayed.
Alarm number or hourly time signal
3.
Press (A) to turn off the displayed alarm or
the hourly time signal.
Each press of (A) toggles between on
●
and off.
Turning off all alarms will cause [ALM]
●
(alarm) to disappear from the display,
while disabling the hourly time signal
causes [SIG] (hourly time signal) to
disappear from the display.
Note
If [ALM] (alarm) is still displayed, it
●
means that another alarm is still turned
on. To turn off all of the alarms, repeat
steps 2 and 3 until the [ALM] (alarm)
indicator is no longer displayed.
Watch Operation Guide 3545
The stopwatch measures elapsed time in units
of 1/100 second up to 23 hours, 59 minutes,
59.99 seconds (24 hours).
When this maximum limit is exceeded,
elapsed time measurement returns to 0 and
timing continues from there.

Measuring Elapsed Time

1.
Enter the Stopwatch Mode.
Navigating Between Modes
l
Minutes, seconds,
1/100 seconds
2.
Use the operations below to measure
elapsed time.
3.
Press (A) to reset the measurement time
to all zeros.
Stopwatch
Hours
Start
Stop
Resume
Stop

Measuring a Split Time

1.
Enter the Stopwatch Mode.
Navigating Between Modes
l
Hours
Minutes, seconds,
1/100 seconds
2.
Use the operations below to measure
elapsed time.
Pressing (A) displays the elapsed time
●
from the start of a race up to the point
when you pressed the button (split
time).
D
Start
A
Split
A
Split release
D
Stop
3.
Press (A) to reset the measurement time
to all zeros.
12