Inputs And Controls; Input Wiring; Pass Output; Power Light - Jensen LXA600 How To Install And Operate

LXA600

Inputs and Controls

Input Wiring

Inputs may be high level (from the receiver's speaker) or low level (from special low level outputs). Low
level input is preferred for best performance.
Low Level Input
Use a pair of shielded stereo audio cables with RCA type jacks. Most trunk-mount
amplifier installations require 20-foot RCA cables. Most under-seat and pickup truck
installations use 12-foot cables.
Connect RCA cables from your receiver to the RCA input jacks on the amplifier.
High Level Input
Connect left and right speaker wires coming from radio to high level input plug
as shown.
Splice
(as necessary)

Pass Output

Use pass through (PASS) connectors
for adding other amplifiers.
PASS

Power Light

The power light comes on when
12 volt power is available at both
POWER
the battery +12 volt and RMT wires.
6022Eamp.p65
A
A
POWER
HI INPUT
B B
PASS
LOW INPUT
A A
HI INPUT
B B
LOW INPUT PASS
5
C C
HI INPUT
D
D
LOW INPUT PASS
Important
Use only the low level or
C C
high level input, do not
use both at one time.
HI INPUT
D
D
LOW INPUT PASS

Protect Light

The red protect light comes on
when the amplifier shuts down
from overheating or a short circuit
PROTECT
(speaker failure).
02/08/01, 4:27 PM
®
PROTECT
White-Left (+)
White/Black-Left (–)
Gray-Right (+)
Gray/Black-Right (–)
Black (ground)
5