EverFocus EBN Series Quick Installation Manual page 7

Waterproof Ring
b. Connect the RJ-45 cable to the LAN/PoE Cable of the camera.
LAN/PoE Cable
c. Tightly screw the Cable Gland and Screw Cap to the Rugged RJ-45
Connector Cable.
d. Crimp the RJ-45 connector onto the RJ-45 network cable. Note that
the wires should be placed into the RJ-45 connector based on the
following order (from left to right).
Orange with white stripe
Orange
Green with white stripe
Blue
Blue with white stripe
Green
Brown with white stripe
Brown
5. Connect the camera to power. You can either connect the camera to a
12VDC power source or to a PoE switch using the PoE cable.
6. Access the camera live view. See 4. Accessing the Camera.
7. Adjust the pan/tilt/rotate angles of the camera by loosen the
Pan/Tilt/Rotate screws using the supplied Hexagon Wrench.
Cable Gland
RJ-45 Cable
Screw Cap
Cable Gland
Rotate Screws (both sides)
Tilt Screw
Pan Screw
Stopper Screw Cap
6