EverFocus EBN Series Quick Installation Manual page 5

4. Screw the Camera Base to the surface using the supplied 3 Screws.
5. Place the camera body back to the Camera Base and twist back the
Outer Housing. Do not twist the Outer Housing too tight as you will
have to adjust camera angles while viewing camera live view.
6. Connect the camera to the network using the supplied Cable Gland Kit.
a. Insert a RJ-45 network cable (without the RJ-45 connector on the one
end) through the supplied Waterproof Ring, Cable Gland, Stopper
and Screw Cap accordingly.
Waterproof Ring
b. Connect the RJ-45 cable to the LAN/PoE Cable of the camera.
LAN/PoE Cable
c. Tightly screw the Cable Gland and Screw Cap to the Rugged RJ-45
Connector Cable.
d. Crimp the RJ-45 connector onto the RJ-45 network cable. Note that
the wires should be placed into the RJ-45 connector based on the
following order (from left to right).
Cable Gland
RJ-45 Cable
Screw Cap
Cable Gland
Stopper Screw Cap
4