How To Remove Panels - Hoshizaki KMD-530MRJZ Instruction Manual

• Remove the protective plastic film from the panels. If the icemaker is exposed to the sun
or to heat, remove the film after the icemaker cools.
• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade (if applicable) turns freely.
• Check that the compressor is snug on all mounting pads.
• The icemaker can be installed on a dispenser unit or ice storage bin. The dispenser
units and ice storage bins listed below are recommended.
Model Number Bin Width
KMD-460M_J
KMD-530M_J(Z)
For further options, contact your local Hoshizaki distributor.
• NOTICE! Remote models must be connected to an appropriate remote condenser
unit. The remote condenser units listed below are recommended. Connection to a
different remote condenser unit will void the warranty unless Hoshizaki approves
a different remote condenser unit for your specific application. For further
details, contact your local Hoshizaki distributor.
Model Number Recommended Hoshizaki Remote Condenser Unit
KMD-530MRJZ URC-5FZ
C. How to Remove Panels
See Fig. 1
• Front Panel: Loosen the screws. Lift up and towards you.
• Top Panel: Lift up at front slightly, push rearward, and lift off.
• Right Side Panel: Remove the screw. Slide forward slightly and lift off.
• Insulation Panel (A): Lift up slightly, and pull towards you.
• Top Insulation: Lift off.
Recommended Hoshizaki
Dispenser Unit
30" or Wider DB-200 or DM Series
Fig. 1
Recommended Hoshizaki Ice
Storage Bin
B-500 Series
Top Insulation
Insulation Panel (A)
Front Panel
12
Top Panel
Side Frame
Right Side Panel