Commissioning, inspection, maintenance
Removing the burner
3. Remove the cover panel; see page 30.
4. Disconnect cables from fan motor
ignition and ionisation electrode
and earth tab
.
E
5. Undo the fitting from gas supply pipe
Checking the burner gasket and burner gauze assembly
Check burner gasket
A
E
for possible damage and replace if required.
B
Fig. 30
1. Remove electrodes
B
2. Undo 2 retaining clips
and then remove thermal insulation ring
D
3. Undo 2 Torx screws and remove burner gauze
assembly
with gasket
E
4. Insert new burner gauze assembly
gasket
and secure.
F
Torque: 5.0 Nm.
40
(cont.)
, gas train
A
, ignition unit
C
.
F
and burner gauze assembly
F
E
2x
.
on thermal insulation ring
C
D
.
F
with new
E
6. Undo four screws
!
,
Please note
B
Prevent damage to the burner.
D
never rest the burner on the burner gauze
assembly.
D
A
2x
C
5. Fit thermal insulation ring
6. Fit electrodes
.
Torque: 4.5 Nm.
G
and remove the burner.
.
D
.
B