Table of Contents
Advertisement
2.
Use the three "SCREWS" to fix the "FRAmE SET" on a "CAmERA" installation
position.
FRAME SET
ADAPTOR
SCREW
3.
Connect external cables to the "CONNECTORS(ALARm IN, POWER, RS-485,
ALARm OUT)"and connect the "CONNECTOR" to the "ADAPTOR".
Insert the cable into the "FRAmE SET", and close the "ADAPTOR".
POWER INPUT
ALARM IN
Then, wrap the "BNC JACK" with the "INSULATION TUBE", and use an insulation
M
tape to seal up the end of the "INSULATION TUBE" so that the "BNC JACK" does
not protrude outside of the "INSULATION TUBE" coating.
For more information about cable connection, refer to "Connecting the adaptor
cable". (page 19)
SCREW
SCREW
ALARM OUT
RS-485
<Fixing Hole Diagram>
FRAME SET
ADAPTOR
SNAP FIT
BNC JACK
INSULATION TUBE
English _11
Advertisement
Table of Contents
