Delta 36-260 Instruction Manual page 6

5. Make sure the bracket knobs are turned to the locked
position when correctly positioned on the stand and
tighten the nuts on all four corners of the saw.
Note: Make sure the saw is centered and balanced over
stand rails.
You are now ready to use your new saw stand.
FOR INSTALLATION WHEN MOUNTING BRACKETS DO NOT ALIGN WITH SAW MOUNTING
HOLES
1.
Mark the saw's mounting holes on a wood board
(minimum 1/2 in. thick, not provided). Make sure board
is large enough to accomodate the mounting bracket
hardware.
2.
Drill 1/4 in. holes. Mount saw to board using bolts,
washers, and nuts (not provided).
Note: Use hardware provided to mount the board/saw to
the mounting brackets.
ASSEMBLY (continued)
3.
4.
5.
6
Place mounting brackets (B) upside down on the top
of the board. Mark hole locations and drill 1/4 in. holes
at marks. Repeat for remaining bracket (B).
Place mounting brackets (B) right side up underneath
the board. Align hole and insert the two bolts (CC).
Place washers (DD) on bolts and secure with nuts
(BB). FINGER TIGHTEN only. Repeat for the other
side.
Once both sides are fastened, return unit to the stand
and position saw on stand, turn knobs to the lock
position on the mounting brackets. Tighten all bolts.