Advertisement
Step 3
O16
NOTE
The remainder of the building assembly
requires many hours and more than one
person. Do not continue beyond this
point if you do not have enough time to
complete the assembly today. A partially
assembled building can be severely
damaged by light winds.
Each screw and bolt in the wall re-
quires a washer.
CORRECT
1
Position front corner panels at the
corners of the fl oor frame as shown.
The widest part of each corner panel
must be placed at the front of the build-
ing. Fasten the corner panels to the
fl oor frame with two screws.
2
Position rear corner panels at rear
of building as shown. The widest part
of each corner panel must be placed
along side of the building. Fasten
corner panels to the fl oor frame using
four screws.
NOTE
The wall panels come in two
widths. Each wall panel has a
crimped rib on one side. The
crimped rib should go under the
rib of the panel that follows it.
3
Attach wall panels to the sides,
as shown.
NOTE
Be careful to install the correct
panel in each position as shown.
4
Double-check the part numbers of
the wall panels, before proceeding.
Parts Needed For
Corners/Wall Panels
STEP
INCORRECT
SUPPORT THE CORNER PANEL
WITH A STEP LADDER UNTIL A
WALL PANEL IS ATTACHED.
9393
WideSide
STEP
2
SIDE
9389
1
7332
9389
Panels rest on
frame as shown
16
9389 Front Corner Panel (2)
9393 Rear Corner Panel (2)
7332 Wall Panel (2)
Narrow
Side
REAR
TOP VIEW
FRONT
Washer
9393
9389
The fl oor frame must be square
and level or holes will not align.
9393
SIDE
9389
Crimped Rib
Underneath
9393
7332
STEP
3
Advertisement
